A Signs Home | SignTools Main Page | Register SignTools | Downloads | Order Online |

Distributors | Support | FAQ (Frequently Asked Questions) | SignTools Tips | CorelDRAW Tips |

Step by Step Setup Instructions for your Cutter |

SignTools 3 Setup Notes for a Lynx S-60


SignTools Settings

After installing Corel DRAW the next step is to install SignTools. Follow the instructions on 4 and 5 of the SignTools 3 User Guide.

Once you have installed SignTools 3, open Corel Draw, click on the Application Launcher (see picture below) and choose SignTools 3.




Next click the Cut button, followed by the Cut Settings button. Select the Lynx S-60 from the Cutter drop down box and select your port.

Please note: If the Lynx S-60 is not listed in the SignTools Cutter drop down click on the Update button in the SignTools Cut Settings dialog.

You must use a Serial (Com) port. 
Next click on the "Properties" button and set the following options.

Bits per second : 9600 
Data bits: 8
Stop bits: 1
Flow Control: Hardware

Plotter Configuration (Dip Switch Settings)

Below are the recommended Dip Switch Settings
1 2 3 4 5 6 7 8
u d u u d d d d

u = Dip Switch Up  d = Dip Switch Down

IMPORTANT: You must use a RS-232-C serial cable for plotters. If the serial cable you are using wasn't supplied with the cutter, it is more than likely that it is not a RS-232-C cable.

CorelDraw Settings

Setup a Landscape page in CorelDRAW of 3200mm x 590mm (126 x 23.2 inches) To do this follow instructions below. (a) Go to the Layout menu and choose Page Setup.
(b) In the Dialog box that appears, make sure you choose Landscape and type in the page size and click OK.

To set this as a default page in CorelDRAW 7 click on the Tools menu and choose Setting for New Documents. Make sure all of the options are ticked and click on the Save Settings Now button.

To set this as a default page in CorelDRAW 8, 9, 10 or 11 click on the Tools menu and choose Options. Click on the word Document on the left hand side and ensure all of the options are ticked and click on the OK button.

To cut any object in CorelDraw, simply place on the page in the bottom left corner. If you wish to cut in a portrait fashion simply rotate your graphics.

Additional note

SignTools 3 cuts from the bottom left of the page either manually place object(s) in the botton left of the CorelDRAW page or use the "Vinyl Saver" tool with the sliding bar all the way to the left.

Other SignTools Support Pages

SignTools Frequently Asked Questions

SignTools Support Enquiry Form

SignTools Activation Help


Copyright All rights reserved.
Revised: October 10, 2009.